Idiomas disponibles
Idiomas disponibles
Configuring the HighLighter Elite
Selecting Single- or Dual-Color (if equipped)
The device can be made to either flash a single color or two colors. This is
done separately for Mode 1, 2, or 3.
To select single- or dual-color:
1.
Activate the mode for which this color feature is to be set.
2. Connect and hold the green wire to the power until the light pulses
three times, and then release it.
3. The device cycles between settings: primary Single-Color, secondary
Single-Color, and Dual-Color.
Selecting the Color Order
You can set the order in which a light flashes. The order is selected
separately for Mode 1, Mode 2, or Mode 3.
To select the color order:
1.
Activate the Mode for which this color feature is to be set.
2. Hold the green wire to the positive voltage source until the light
pulses four times, and then release the wire. The device switches
color from the initial setting to its opposite. For example, a dual-color,
amber-red light set to flash amber then red will change to flashing red
then amber. A dual color, amber-red light set to the single color red
will become amber.
Selecting Dim Mode
The device can be made to function in Dim Mode. This can be set
separately for Mode 1, Mode 2, or Mode 3.
To activate Dim Mode:
1.
Activate the Mode for which this feature is to be set.
2. Hold the green wire to the positive voltage source until the light
pulses six times, and then release the wire. The Mode switches from
its initial setting to its opposite. The normal setting becomes "Dim
Mode" and vice versa. Changing the pattern will reset the Dim Mode
to off.
20
Federal Signal www.fedsig.com
HighLighter
Elite
®
