Hitachi PC-ARFP1E Manual De Instalación Y Funcionamiento página 11

START UP PROCESS
3 START UP PROCESS
1 Turn ON the power supply for all the indoor units.
4 OPERATION METHOD
4.1 OPERATION START
Press " " (run/stop). The run indicator will be turned on and the
operation will be started.
OK
4.2 OPERATION STOP
Press " " (run/stop) again. The run indicator will be turned off
and the operation will be stopped.
OK
4.3 BASIC OPERATION
1 Item Selection.
By pressing " "or " ", the icon "
item in order of the indications "MODE", "SPEED", "LOUV."
and "TEMP".
OK
/ ?
3 PMML0496 rev.1 - 12/2020
Meeting Room
A/C
MODE SPEED LOUV. TEMP
COOL
MODE LOUV. Adj.
A/C Meeting Room
MODE SPEED TEMP
COOL
MODE TEMP Adj.
" will move to the next
Meeting Room
A/C
MODE SPEED LOUV. TEMP
COOL
MODE LOUV. Adj.
2 For the models with the auto-address function, wait for 3
minutes approximately. The addressing is automatically
performed. (There are cases in which 5 minutes may be
required depending on setting conditions.) After that, press "
" (menu) and select using language from
in
Setting" "8.19 Screen display setting"
?
N O T E
Temperature / Air Flow Setting: The setting condition will be memorized
once after the setting is confirmed, therefore the daily setting is not
required.
?
N O T E
The indoor unit fan may continue to operate for up to two minutes following
the heating cycle to dissipate residual heat from the indoor unit.
2 Change of Settings
With the item ("MODE", "SPEED", "LOUV" or "TEMP")
selected, press " " or " ". The setting will be changed.
OK
/ ?
"8.19.2 Language
menu.
A/C Meeting Room
MODE SPEED LOUV. TEMP
HEAT
SPEED Adj.