Hitachi PC-ARFP1E Manual De Instalación Y Funcionamiento página 15

POWER SAVING GUIDE
5 POWER SAVING GUIDE
This function easily sets the power-saving feature.
Depending on the type and setting of the indoor unit and outdoor
unit it may be impossible to set this function.
?
N O T E
: Unable to set: If a function displaying "
"No Function" will be displayed on the lower screen.
1 Press "ECO": The Power Save Guide will be displayed as
shown in the image near the bottom of this page.
OK
/
?
2 The current setting status is displayed for "Power Saving
Mode", "Power Saving ON/OFF", "Power Saving Level" and
"Schedule". It is possible to change the "Sav ON/OFF" and
"Sav Level" settings. (*1).
Power Saving ON/OFF Setting:
•
Press " " or " " and select "SAV ON/OFF". By pressing " "
or " ", the setting will change between "ON" ↔ "OFF". (*2)
Power Saving Level:
•
Depends on the configuration selected in "Change level"
of the
"8.5.3 Power saving detailed setting (Intermittent operation
menu.
control)"
Press " " or " " and select "Sav Level". By pressing " "
or " " the setting will change between "LOW" ↔ "MED" ↔
"HIGH". (*2) (*3)
Power Save Guide
Sav Mode
OK
/ ?
Sav ON/OFF
Sav Level
Schedule
Detailed Setting
SEL.
A/C
OK
/ ?
MODE SPEED
COOL
Sav:HIG
SPEED
The icon "Sav: HIG/MED/LOW" is
OK
/ ? displayed when "Power Saving" is
ON in COOL,HEAT and DRY modes
7 PMML0496 rev.1 - 12/2020
" is selected from the "Menu",
Meeting Room
A/C
MODE SPEED TEMP
COOL
SPEED ADJ
Capacity Cntl
ON
HIGH
No Setting
ADJ
RTN.
Meeting Room
TEMP
ADJ
?
N O T E
• *1: When the Power Saving Mode is "Rotation Control", the "Power
Saving Level" and "Schedule" are not displayed. When the Power
Saving Mode is "No Setting", the "Power Saving ON/OFF", "Power
Saving Level" and "Schedule" are not displayed.
• *2: When the Power Sav Mode is "Capacity Control" and Remote
controller is set as SUB, it is not possible to change the settings for
"Power Saving ON/OFF" and "Power Saving Level".
• *3: When Power Saving is OFF, the "Power Saving Level" cannot be
changed.
• Detailed Setting:
Press " " or " " and select "Detailed Setting". By pressing
"OK", the Detailed Setting screen will be displayed.
3 Press " " or " " and select the setting function. By pressing
"OK", each type of setting will be displayed.
Refer to the following concerning each setting.
• Power Saving Mode Setting (Section
• Detailed Setting (Section
• Schedule (Section
"8.9 Power Saving / Operation Noise Reduction
).
Schedule"
OK
/ ?
OK
/ ?
"8.5 Power saving"
)
"8.5 Power saving"
Detailed Setting
Power Saving Mode Setting
Detailed Setting
Schedule
Change power saving mode used.
SEL. ENT.
OK
RTN.
")