Hitachi PC-ARFP1E Manual De Instalación Y Funcionamiento página 39

TEST RUN MENU
6.10 MAIN REMOTE SETTING
Remote controller is configured as MAIN by factory default. This function changes between "SUB" to "MAIN" controller.
The following is an example of an installation containing a group of multiple controllers:
The indoor and outdoor units must be compatible with the functions shown in the table below.
Some outdoor units cannot use the "Power Up Setting"* and "Quick Function"* settings.
On/Off On/Off
ECO ECO
Main Sub
Concerning main and sub controllers, the range of settings may differ for the functions shown below.
Power saving mode setting
Outdoor unit capacity control
Indoor unit rotation control
Intermittent control
Operation noise reduction
Power saving schedule
Operation noise reduction schedule
Power up setting*
Quick function*
○: Available ×: Not Available
1 Press and hold " " (menu) and "
simultaneously for at least 3 seconds during the normal
mode (when unit is not operated). The test run menu will be
displayed.
Test Run Menu
Indoor Unit Address Change
Address Check Operation
Address Initialization
Setting Initialization
Main Remote Setting
Sel.
ADJ
2 Select "Main remote setting" from the test run menu pressing
" " and "OK". This menu is only available when the
remote controller is configured as SUB.
31 PMML0496 rev.1 - 12/2020
H-LINK Control Cable
Controller
cable
On/Off
ECO
Sub
Function
Detailed setting
Power saving level switch
Detailed setting
ON/OFF
Detailed setting
Power saving level switch
Outdoor capacity control
Intermittent control
" (return / help)
/ ?
02
/
03
OK Entr Rtrn
Main controller ... Only one controller in same refrigerant system
Sub controller ... Controller in addition to the main controller in
the same refrigerant system
3 The confirmation screen is displayed.
Setting of the Main Remote Control
Change to main remote even if
each setting is initialized?
Yes
Sel.
4 Select "Yes" and press "OK". The test run menu will be
displayed after the setting is confirmed. If "No" is pressed,
the screen will return to test run menu.
5 After the change is applied, the Power Save Mode reads:
"No Setting".
Also, the power saving "Detailed Settings", "Power Saving",
"Save/Reduction Schedule", "Operation Noise Reduction",
"Priority Setting" and "Power Up Setting" functions are
initialized.
6 Reset the settings.
7 Press " " (return / help) on the test run menu to return to
/
?
the normal mode.
Main Sub
○ ×
○ ×
○ ×
○ ×
○ ○
○ ○
○ ○
○ ×
○ ×
○ ○
○ ×
○ ×
○ ○
No
OK
Entr Rtrn