Idiomas disponibles
Idiomas disponibles
English
► Tighten the star handle
12A
12B
4
4
1x
1x
2x
4
1x
4
,
2x
4
,
10.9 Sawing grooves
The continuously adjustable groove depth limit
can be used to individually define groove areas
using the total cutting depth. Grooving or facing
is therefore possible at any height for any work
piece size.
24
.
0 - 45°
46 - 47°
0 - 45°
46 - 47°
The round shape of the saw blade means
that, when grooving, a slight cutting curve
upwards is required. For grooving that is
precisely horizontal, a tap block must be
clamped between the workpiece and the
stop ruler so that a clearance of
1-9/16"(4 cm) can be guaranteed.
► Move the machine into the working position.
Only turn down the lever for the groove
depth limit [1-5] if the saw unit is in the
upper position (= working position).
► Pull the lever for the groove depth lim
it [1-5] all the way to the front.
The saw unit can now be pushed down only
as far as the preset cutting depth.
► Turn the lever for the groove depth limit to
set the required depth (turn to the left = in
5
crease the groove depth, turn to the right =
decrease the groove depth)
Push down the saw unit as a trial run to check
whether the groove depth limit is set to the re
quired groove depth.
Only push the saw unit down when the lev
er for the groove depth limit has engaged
in one of the two end positions. Risk of
damage to the power tool.
► Make the cuts.
► To deactivate the groove depth limit, reset
the lever [1-5].
11 Maintenance and care
Risk of injury, electric shock
► Remove both battery packs from the power
tool before performing any work on the
power tool.
► All maintenance and repair work which re
quires the motor housing to be opened
should always be carried out by an author
ised service workshop.
WARNING
