Idiomas disponibles
Idiomas disponibles
English
7.3
Working position
CAUTION
When the lever for the transport locking de
vice [1-7] is pulled, the saw unit moves up
wards quickly.
► Always hold on to the handle [1-4] when
pulling the lever for the transport safety
device.
Unlocking the machine (working position)
► Swivel the saw unit into a vertical position
(saw blade is vertical) [12].
► Move the saw unit downwards as far as the
limit stop and hold it there.
► Pull the lever for the transport locking de
vice [1-7].
► Slowly guide the saw unit upwards.
► Insert the battery pack (see section 8).
The machine is ready for operation.
7.4
Switching on/off
► Move the machine into the working position
or release the lock on the saw unit.
► Press and hold the safety button [1-3].
► Press and hold the switch-on lock [1-1].
► Press and hold the on/off switch [1-2].
Press = ON
Release = OFF
8
Battery pack
Before using the battery pack, check that the
battery interface is clean. Any contamination of
the battery interface may impair correct contact
and lead to the contacts being damaged.
A faulty contact may result in the machine over
heating or being damaged.
[5A]
Remove the battery pack.
[5B]
Insert the battery pack – until it
clicks into place.
16
5A
2
5B
1
Please note: The machine can only be op
erated under the following conditions [5C]:
Both battery packs are used. Maximum
power with two battery packs (36 V).
Only the front battery pack is used. Less
power with one battery pack (18 V).
5C
Further information about the charger and
battery pack with capacity indicator can be
found in the corresponding operating
manual.
2
1
1
2
2
1
