Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Flywheel Locking Pin – Silver (Early Engines)
Flywheel Locking Pin – Gold (Later Engines)
WARNING: Under certain circumstances it may be possible to insert the (no.2) for later engines into
the flywheel of early engines. However it will not feel a good, positive fit and it will not be possible to fit
the securing screw for the Pin as the securing hole will be off-set. If this occurs, remove and fit (no.1).
Camshaft Setting Plates
In order to check the camshaft timing the camshaft covers must be removed. With the crankshaft
locked in 'timed' position the 'timing flats' on the camshaft should be uppermost.
One of the (no.3) is placed across the 'timing flats' on the left-
hand bank of camshafts and the other Plate is located across the
'timing flats' on the right-hand bank.
IMPORTANT: References made to left-hand bank and right hand
bank are as viewed from the direction of the camshaft gears.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Fig. 2a
Fig. 3a
Fig. 4a
Tel.: 02196 720480
Fax.: 02196 7204820
Fig. 2b
Fig. 3b
Fig. 4b
Fig. 5
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Tabla de contenido
