Intended Use; Important Safety Instructions - BGS technic 1677 Manual De Instrucciones

Dent Repair Kit with Sliding Hammer

INTENDED USE

This product is for pulling out edges and dents. The tool is supplied with pulling hooks, pulling bolts
and adaptor set for various dents. Each accessory has been specially made for this use.

IMPORTANT SAFETY INSTRUCTIONS

Please read these safety instructions well before you use the device!
Special attention and caution are things that cannot be integrated into any product
• Do not use the product under the influence of alcohol or drugs.
• Make sure your senses / reflexes are not affected.
• Take care of your safety, always wear safety goggles, ear protection, protective gloves and non-
slip shoes when working with this product.
• Never allow children to play with tools or their packaging.
• Check the product for damage before use. Do not use the product if any parts show cracks or
damage.
• Do not keep your hands in the area of the slide bar. There is a risk of crushing!
DELIVERY
1 Sliding hammer weight
1 Sliding bar, outer thread 5/8"x18UNF
1 Handle, inner thread 5/8"x18UNF
2 Pulling hook, 30 mm, inner thread 5/8"x18UNF
1 Stop nut 5/8"x18UNF
2 Pulling hook, round
2 Pulling bolt
1 Adaptor (for pulling hook & bolt), inner thread 5/8"x18UNF
1 Adaptor, inner thread 5/8"x18UNF to outer thread
USE
1. Screw the stop nut onto one thread side (without spigot) of the sliding bar until it reaches the end
of the thread.
2. Install the handle as far as possible on the same side.
3. Slide the hammer weight over the slide bar.
4. Install a suitable pulling hook on the opposite sliding bar thread, which is equipped with a spigot
at the end of the thread.
5. Attach the pulling hook to e.g. the edge to be pulled out.
6. Hit the hammer weight against to the stop nut and repeat this until the material is completely
pulled out.
SW-Stahl und Werkzeugvertriebs GmbH
5
d i e
6 e s s a r t S
h c s m e R
Tel. +49 (0) 2191 / 46438-0
r e F ax +49 (0) 2191 / 46438-40 s u k r e v e
7 9 8 2 4 - D e
1677
L
d . l h a t s w s @ o f n i : l i