Spare Parts And Tools - Stanley PB2500N NeoBolt Manual De Instrucciones

Note: Stroke
Adjustment pin set
flush to pulling head
Clutch Tab
Position
WORKLIGHT FUNCTION
Refer to section 3.5 Worklight for function check
STROKE ADJUSTMENT SETTING, COLLET & NOSE HOUSING INSTALLATION
Refer to section 3.2 Nose Equipment and 3.3 Stroke Setting and Adjustment
OPERATION CHECK (Fig. 4)
• Set 5-10 Neobolts and check for the following:
• The tool does not slip
• Swaging setting is done in one stroke
• There is no pin tail damage on placed Neobolt
• There is no abnormal noise
APPEARANCE CHECK
Inspect the tool for the folllowing:
• Damage to the Handles (G) or Gear Housing Assembly (E)
• Loose components and screws
• Any oil spots on the housings
• Peeling of the over mold (Rubber grip)
• Blockage of Exhaust Vents (F)
• Illegible or missing warning labels

5.3 SPARE PARTS AND TOOLS

For spare parts refer to "Bill of Material" in section 9
5.3.1 Tools required for maintenance:
• 21mm open end wrench, 1ea (Mast Housing)
• 2mm allen wrench, 1ea (Stroke Adjustment Pin)
• 24mm open end wrenches, 2ea (Anvil and Nose Housing)
Clutch Tab
Position
E N G L I S H
19