Cleaning Click 2 - Weinmann CPAP 20e Descripción Del Aparato E Instrucciones De Manejo

Reset the hours meter
If the fine filter was changed due to soiling before 250 operating hours, the hours meter
must be reset to zero. Proceed as follows:
1. When switching on the unit, press and hold the on/off switch.
The filter change indicator will come on after about five seconds before going off again
after another three seconds.
2. Release the on/off switch.
Accessories
To clean the exhalation system, the mask and the headgear, please see the section "Clean-
ing" in the relevant operating instructions.
To clean the humidifier CLICK 2, please see the section "5.3 Cleaning CLICK 2" on
page 27 of these operating instructions.

5.3 Cleaning CLICK 2

Do not touch the heater rod. The metal takes a long time
to cool down.
1. Open the humidifier by twisting the upper and lower
parts against each other in an counter-clockwise
direction.
2. No water must penetrate into the pressure line during
cleaning or this could lead to incorrect pressure read-
ings. Therefore the pressure line must remain sealed.
To seal the pressure line at the outlet-connections push
the silicone tube of the closure (supplied as standard
CLICK 2) over the end of the pressure line.
Hygienic preparation 27