Tabla de contenido
Idiomas disponibles
Idiomas disponibles
15.4
Operation
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
16.1
Cleaning
Regular cleaning guarantees the long service life of your machine and is a prerequisite for its safe
operation.
Incorrect cleaning products can attack the finish of the machine. Do not use any
solvents, nitro thinners or other cleaning products that could damage the machine's
finish.
Observe the specifications and instructions of the cleaning agent manufacturer.
Remove chips and dirt particles from the machine after each use with a proper tool.
•
•
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil
(e.g. WD40 rust inhibitor).
16.2
Maintenance
The machine is low-maintenance and only a few parts need to be serviced. Malfunctions or defects
that could affect your safety must be repaired immediately!
Before each operation, check the perfect condition of the safety devices.
•
Regularly check the perfect and legible condition of the warning and safety labels of the
•
machine.
Use only original spare parts recommended by the manufacturer.
•
Maintenance plan
The type and degree of machine wear depends to a large extent on the operating conditions. The
following intervals apply when the machine is used within the technical limits:
Interval
for each usage
After 20h and then all
100h
50h
100h
2 years
HOLZMANN Maschinen GmbH
component
Band wheel bearing
Blade guide bearing
Log screws
Engine oil
Air filter
Engine oil
Air filter
Spark plug
Fuel supply lines
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
• Place a log onto the track and secure it with the
log assembled supports.
• Set desired cutting height.
• Start the engine
• Let the engine warm up
• Turn on the lubrication.
• Increase cutting speed by operating the throttle
on the handle.
NOTICE:
Slowly tighten the throttle handle to avoid
stalling the engine
• Slide saw head slowly over the track until cut has
been finished.
• Release the throttle (engine continues to idle)
• Turn off the machine after completing operation
with the OFF-button.
N O TE
activity
Check for wear and if necessary replace it
Check for wear and if necessary replace it
Grease threads
Check oil-level
Check for pollution and clean if necessary
change
clean
Change
change
49
BB810SMART-G
Tabla de contenido
