Fit The Receiver Collar - Petsafe Classic In-Ground Fence Manual De Instrucciones

11

Fit the receiver collar

1. Turn the receiver collar off by pressing and holding the mode
button for 5 seconds. The receiver collar will beep high to low
and the status light turn off.
2. With your pet standing comfortably, place the receiver collar
around your dog's neck. The PetSafe
up, and the contact points should be centred directly under your
dog's chin, touching his skin.
If your dog has long hair, it may be necessary to switch to the
long contact points provided or trim (not shave) the hair around
the contact points.
3. Check the tightness of the receiver collar by inserting one finger
between the end of a contact point and your dog's neck. The fit
should be snug but not constricting.
22
logo should be right side
®
Slide buckle
To loosen
4. Adjust the fit of the receiver collar as needed. Make sure the
ridges on the fasten buckle are facing up and the strap is
threaded through the slide buckle to prevent it from becoming
loose around your pet's neck.
5. Once you are satisfied with the fit of the receiver collar, remove
it from your pet and trim it (making sure to allow room for growth
or a thicker winter coat). Seal the edge of the cut collar by
applying a flame along the frayed edge.
Well done!
You have successfully installed your Classic In-Ground Fence
system. Now it's time to train your pet—see the provided training
guide for detailed step-by-step instructions. We know you and your
pet are going to love the freedom and safety provided by your new
fence system.
Fasten buckle Ridges
To tighten
™