Fit The Receiver Collar - Petsafe PDT20-10644 Manual De Funcionamiento

To Turn the Receiver Collar On:
1. Press and hold the On/Off Button until the Receiver Indicator Light comes on and
the Receiver Collar beeps 5 times.
2. Release the On/Off Button.
Once the Receiver Collar has been turned on, press the Side Button of the Remote
Transmitter. The Receiver Collar should beep for as long as the Side Button is pressed.
If it does not, see the "Reset the Receiver Collar" section.
The Receiver Indicator Light will fl ash once every 4 to 5 seconds if the batteries are low.
To Turn the Receiver Collar Off:
1. Press and hold the On/Off Button until the Receiver Indicator Light comes on and
the Receiver Collar beeps 2 times.
2. Release the On/Off Button.
Note: To extend the life of the batteries, turn the Receiver Collar off when it is not in use.
Important: If the Receiver Collar is left on continuously, the maximum battery life
(before replacing batteries) will be two weeks.
_____________________________________________________________

Fit the Receiver Collar

Step
3
Important: The proper fi t and placement of your Receiver Collar is important for
effective training. The Contact Points must have direct contact with your pet's skin on
the underside of his neck.
Please refer to page 2 for important safety information.
To assure a proper fi t, please follow these steps:
1. Have your pet standing comfortably (3A).
2. Centre the Contact Points underneath your pet's neck, touching the skin (3B).
If your pet has a long or thick coat, use the enclosed long Contact Points to reach
through the hair.
CAUTION
Never shave the dog's neck; this may lead to a rash or infection.
3A
You may need to trim the hair in the area of the Contact Points.
www.petsafe.net
3B
9