Fit The Receiver Collar - Petsafe IF-300 Manual De Adiestramiento Y Funcionamiento

Fit the Receiver Collar

Step
5
Important: The proper fit and placement of your Receiver Collar is important for effective training. The
Contact Points must have direct contact with your pet's skin on the underside of his neck.
To assure a proper fit, please follow these steps:
1. Make sure that the battery is not installed in the Receiver Collar.
2. Start with your pet standing comfortably (5A).
3. To make it easier to hear the warning tone, place the Receiver Collar on your
pet with the logo side of Receiver facing up.
4. Center the Contact Points underneath your pet's neck, touching the skin.
5. Check the tightness of the Receiver Collar by inserting
one finger between the end of a Contact Point and your
pet's neck. The fit should be snug but not constricting
(5B).
6. Allow your pet to wear the collar for several minutes
then recheck the fit. Check the fit again as your pet
becomes more comfortable with the Receiver Collar.
7. Trim the collar as follows (5C):
a. Mark the desired length of the Receiver Collar
with a pen. Allow for growth if your pet is young or
grows a thick winter coat.
b. Remove the Receiver Collar from your pet and cut
off the excess.
c. Before placing the Receiver Collar back onto your
pet, seal the edge of the cut collar by applying a
flame along the frayed edge.
8. Put battery in Receiver Collar.
Please read and follow the instructions in this manual. Proper fit of the collar is important. A
collar worn for too long or made too tight on the pet's neck may cause skin damage. Ranging
from redness to pressure ulcers; this condition is commonly known as bed sores.
• Avoid leaving the collar on the dog for more than 12 hours per day.
• When possible reposition the collar on the pet's neck every 1 to 2 hours.
• Check the fit to prevent excessive pressure; follow the instructions in this manual.
• Never connect a lead to the electronic collar; it will cause excessive pressure on the
contacts.
• When using a separate collar for a lead, don't put pressure on the electronic collar.
• Wash the dog's neck area and the contacts of the collar weekly with a damp cloth.
• Examine the contact area daily for signs of a rash or a sore.
• If a rash or sore is found, discontinue use of the collar until the skin has healed.
• If the condition persists beyond 48 hours, see your veterinarian.
• For additional information on bed sores and pressure necrosis, please visit our website.
These steps will help keep your pet safe and comfortable. Millions of pets are comfortable
while they wear stainless steel contacts. Some pets are sensitive to contact pressure. You
may find after some time that your pet is very tolerant of the collar. If so, you may relax some
of these precautions. It is important to continue daily checks of the contact area. If redness or
sores are found, discontinue use until the skin has fully healed.
You may need to trim the hair in the area of the Contact Points. Never shave the dog's neck;
this may lead to a rash or infection.
You may need to trim the hair in the area of the Contact Points.
Never shave the dog's neck; this may lead to a rash or infection.
www.petsafe.net
5A
5B
5C
11