Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Produzido por Tecnomotor Eletrônica do Brasil S/A - REPRODUÇÃO PROIBIDA - Eventuais erros ou defeitos favor comunicar [email protected]
Start timeout during
current limit starting
E62
(LED Fault)
Flashes twice
(LED Ready) On
Stall
E63
(LED Stall)
Flashing
Overcurrent
E66
(LED Overcurrent)
Flashing
TM 514 – COMMON RAIL TEST
When the starting time
is longer than the time
set in the acceleration
ramp trimpot. Active
only with current limit
starting.
Activates before full
voltage, if the current is
greater than twice the
nominal motor current.
It is only monitored
when the SSW-07 is at
full voltage. When the
parameters are set with
the factory default
values this protection
trips when the motor
current exceeds 2
times the
value adjusted in the
trimpot
(Motor Current) for a
time longer than 1
second.
178
Programmed time for
the acceleration ramp
inferior to what is
needed.
Value of the
programmed current
limitation too low.
Motor locked, rotor
blocked.
Programmed
acceleration ramp
time lower than the
actual acceleration
time.
Motor shaft is locked.
The transformer that
supplies the motor
can be saturating and
taking too much time
to recover from the
starting current.
Momentary motor
overload.
Motor shaft is locked,
rotor blocked.
Power-on.
Reset key.
Auto-reset.
DIx.
Power-on.
Reset key.
Auto-reset.
DIx.
Power-on.
Reset key.
Auto-reset.
DIx.
Tabla de contenido
