Sauna/Hammam
■ The electronic management system fails to interface.
Try turning off and then turning on the main switch and then try to re-start the function: if the
problem persists, contact a Jacuzzi® Service Centre.
Sauna/Hammam
■ The light control system may be faulty.
Contact an authorized Jacuzzi® service centre.
Sauna/Hammam
■ The key panel is not able to communicate with the electronic control system.
Try turning off and then turning on the main switch and then try to re-start the function: if the
problem persists, contact a Jacuzzi® Service Centre.
Sauna
■ The function will stop abruptly.
- The function run time may be over.
- The door may be open; if the door is open for more than 10 minutes the door sensor will
override the function.
Hammam
■ The function will stop abruptly.
- - The function run time may be over.
- The steamer (hammam) resistor may be out of order.
- The door may be open; in this case the function is interrupted if the sensor detects no tem-
perature increase.
Sauna/Hammam
■ It is not possible to activate the display programmes.
Check that, where installed, the remote control system has not been activated; if activated, it
must be disabled in order to be able to use the display (refer to the relative manual).
- Try pressing the key of the selected programme, waiting for it to switch off and press again
within 20 seconds.
- The key panel lock may be engaged (see relative chapter).
- The key panel may be out of order. Contact Jacuzzi® Customer Service.
59