Alarms; Display Lock; Instructions - Jacuzzi sasha mi Manual De Uso Y Mantenimiento

Alarms

Connection to the alarm circuit must be carried out at the installation stage and in compliance
with the warnings detailed in the installation manual.
■ When this key is pressed (for approximately 1 second), it begins to flash and the alarm
indicator is immediately activated (alarms, buzzers, lamps, etc.): this will continue until
the key is pressed again.
ù
- Activation of this function interrupts all other functions in progress (except scale removal cycle
and audio system).
-The alarm function is even available when the display is locked (see the relative chapter).

Display lock

This function locks to display and access to its functions; this function is useful for preventing
unauthorised access to the sauna controls.
■ Ensure that no function is in progress and that the display that you wish to lock is in

instructions

"awaiting instructions" mode (only ON/OFF key lights up white).
■ Press the key to the left of the ON/OFF key and within 3 seconds, the key to the right:
the display will illuminate and the ON/OFF key will begin to briefly flash.
■ At this point select the desired program.
Warning: perform the following procedure if the Jacuzzi® remote control system has
been installed: press the key of the program selected, wait for it to go dim and press
again within 20 seconds.
■ The display remains illuminated (thus not going into stand-by).
■ To deactivate the function, press the "ON/OFF" key and within 3 seconds, the "alarm"
+
key (this operation must be performed on the same display used to set the lock).
ù
- The lock only effects the display to which the lock was applied.
- Once the display has been locked, no other functions aside from the one selected may be
used; the sound system and alarm functions are however still available; if activated, this last
function interrupts the active programme; the display is still locked regardless whether the
alarm is activated or the programme in progress ends on its own.
- If a programme is activated via the Jacuzzi® remote control system (where installed), the
relative display is locked and remains this way until terminations of the programme.
52