Scaff-Trac Parts List; Installing Scaff-Trac Monorail - Beta Max Beta Lite Manual Del Usuario

Scaff-Trac Parts List

1. Two saddles (A)
2. One 11-foot Scaff-Trac Monorail/Trac (B)
3. Four mounting pins with keepers (C)
4. Inboard end retaining pin (D)

Installing Scaff-Trac Monorail

1. Place one saddle (A) over the center of each of the scaffold frames. The holes
in the saddles should line up. Two sets of holes on each saddle allow for
variations in scaffold frames.
2. Raise both ends of the Scaff-Trac Monorail/Trac (B) to the under side of the
saddles (A).
3. Insert the pins and keepers (C) into the same set of holes on each saddle.
4. Once the hoist is mounted, insert inboard end retaining pin (D).
NOTE: Check the Scaff-Trac with a level. If Scaff-Trac is not level, adjust until it is
level. Unit must be level for correct hoist operation.
www.betamaxhoist.com
1-800-233-5112
Scaff-Trac Parts List
Table 5.3
Item
A Saddles
B 11-foot Scaff-Trac Monorail/Trac
C Mounting pins with keepers
D Inboard end retaining pin
E 7-foot Scaff-Trac Extension
Description
5-17