Controls; Model Identification; Operating Instructions; Starting And Stopping The Engine - GOLDONI ECO 3+2 Manejo Y Cuidado

18.Tag plates and sticker are essential means of information on correct use of
the machine. Replace them when they are illegible or badly worn.
19.The operator must check to be certain that every part of the tractor and,
especially the safety devices, are in good working condition and work to
specs. They should be kept in perfect working condition. If you note any
malfunctioning, fix or repair them in good time. If necessary contact your
nearest Assistance Centre. Failure to observe these instructions releases
manufacturer from all liability.
Pay special attention to the stickers on the machine.
Fig.6: refer to this Operating and Maintenance Instruction Manual.

2. CONTROLS

See fig.1.
1 Throttle control lever.
2 Clutch lever.
3 Gear lever.
4 Reverse lever.
7 PTO lever.
8 Engine stop lever (Motorstop).
9 Wheel release lever.
10 Handle release lever.

3. MODEL IDENTIFICATION

Model, series and chassis number are the machine's identification data.
For ECO 3+2 motor mowers, the data plate is on the left of the handlebars.

4. OPERATING INSTRUCTIONS

4.1 STARTING AND STOPPING THE ENGINE

Gear lever (n.3 fig.1) in neutral.
PTO lever (n.7 fig.1) in neutral.
Reverse lever (n.4 fig.1) forward.
(see fig.4)
To start the engine, lock the Motorstop lever B in its fully lowered position. Pull
the clutch disengage lever C and insert retainer A under the lever so that the
clutch is disengaged. In this way, both levers are locked to prevent the engine
being started with a gear engaged.
Start the engine following the instructions given in the engine Operating and
Maintenance Instruction Manual.
Pull the clutch lever up again and retainer A is released so that either the
Motorstop or the clutch lever can be used.
To stop the engine, release Motorstop lever B.
30