Kyocera KM-6230 Manual De Instrucciones página 19

1 Auto continue
If a printer error such as a paper mismatch error occurs, printing can
be set to restart automatically after the amount of time specified
here. In this case, the print job will NOT be stopped. If, however,
"OFF" is selected here, the print job WILL be stopped whenever a
printing error occurs. If "0 Min" is selected, the error will be ignored
and printing will continue.
Press the "–" or "+" key to select either "0 Min", "2 Min", "5 Min",
"10 Min", "20 Min" or "OFF".
* The factory default setting is "2 Min".
2 Receive buffer
The receive buffer function allows you to set the amount of system
memory allocated for data received from the I/F Board to be spooled
before it is printed. Setting the buffer to a larger value allows more
data to be received from the computer, thereby reducing the amount
of computer down time during printing.
Press the "–" or "+" key to select either "24 KB", "500 KB", "700 KB"
or "990 KB".
* The factory default setting is "500 KB".
3 Form Feed Time Out
It is possible to set the maximum amount of time that the printer will
wait to receive data from the computer. If the printer does not receive
any data from the computer within the amount of time specified here,
printing will be canceled.
Press the "–" or "+" key to select either "30 Sec.", "60 Sec.",
"120 Sec.", "180 Sec.", "240 Sec." or "300 Sec."
* The factory default setting is "30 Sec."
All manuals and user guides at all-guides.com
Section 2 Using the Printer
4 Parallel Interface
Both bi-directional and high-speed modes are supported.
Select the desired mode from "Auto", "Nibble high", "Normal" and
"High-Speed" using the "–" key or "+" key.
* By default, "Auto" is selected.
* If the page contained unnecessary pages or unknown character
was printed out, please change the setting and print again.
5 Page Protect
A print overrun error may occur in case of complex print data. In this
case, select "ON" to allow printing of such data. If "Auto" is selected,
printing speed will drop slightly.
"Auto" or "ON" can be selected by using the "–" key or "+" key.
* By default, "Auto" is selected.
* For detailed on error messages, refer to "2-6.When This Message
is Displayed...".
2-10