Fastening The Inverter To A Flat Surface - Schumacher Electric PI-1000 Manual Del Propietário

6. Analog Output Power Display – Shows 120V AC
continuous power consumed. Five lights indicate half
of the continuous output power and ten lights indicate
full continuous power consumption. When the inverter
is OFF, no lights appear.
7. Positive Battery Cable Terminal (Red) – Accepts
Positive connector cable.
8. Negative Battery Cable Terminal (Black) – Accepts
Negative connector cable.
9. Ground Terminal – Grounds inverter to reduce
electrical shock.
10. Thermal Protection – When the inverter case be-
comes hot (exceeds 145° F) the inverter shuts down.
11. Surge Protection – When the power input from the
vehicle's battery exceeds 15-volts the inverter shuts
down.
12. Low-Battery Protection – When the power input
from the vehicle's battery drops to approximately
10-volts the inverter shuts down.
3. fASTENING THE INVERTER TO A fLAT
SURfACE
For convenience your inverter can be fastened to a flat
surface, horizontally or vertically. The area where the
inverter is to be fastened must be dry, well ventilated and
away from any combustible material or fumes.
1. Turn off and disconnect the inverter.
2. Place the back of the inverter with the mounting
bracket against a secure and flat surface.
All manuals and user guides at all-guides.com
• 7 •