If The Inverter Fuse Blows - Schumacher Electric PI-1000 Manual Del Propietário

2. When the power input from the vehicle's battery
exceeds 15-volts, high voltage overload protection oc-
curs. Solution: Reduce the voltage range to between
12-volts and 14-volts.
3. The continuous load demand from the equipment
or device being operated exceeds the continuous
load rating of the inverter being used. Solution: Use a
higher capacity inverter or lower rated device.
4. The case temperature becomes hot (exceeds
145°F). Your inverter is fitted with a cooling fan that
runs as needed while the inverter is operating. If the
cooling fan is unable to maintain a cool enough tem-
perature for safe operation, the inverter will automati-
cally shutdown. Solution: Allow the inverter to cool. Do
not block the cooling slots or air flow over and through
the inverter. Reduce the load on the inverter to the
continuous rated output.
RESET: To reset after shutdown occurs, turn the inverter
rocker switch to the OFF (O) position. Check the source
of the problem and correct. Turn the inverter switch to
the ON (I) position.
12.

If THE INVERTER fUSE bLOWS

Your power inverter is fitted with a fuse, which should
not have to be replaced under normal operating condi-
tions. A blown fuse is usually caused by reverse polarity
or a short circuit within the device or equipment being
operated.
If the fuse does blow, take the inverter to a qualified
technician for repair.
All manuals and user guides at all-guides.com
• 16 •