Preparing To Work; Checking The Machine - GGP ITALY SBC 425 H Manual De Instrucciones

– I nsert the supplied wrench (5) in the specific
hole, then turn the blade (3) by hand and push
the wrench (5) until it enters the hole of the an-
gle transmission (2), blocking rotation.
– U nscrew the nut (7) clockwise and remove
the cup (6).
– P ull out the outer ring-nut (4), then remove the
blade (3) and the inner ring-nut.
1.3.3 Cutting line head (Fig. 5)
a) Assembly
– F it the inner ring-nut (1) in the indicated direc-
tion, making sure that the inner ring-nut's (1)
grooves match perfectly with those of the an-
gle transmission (2).
– I nsert the supplied wrench (3) in the specif-
ic hole of the inner ring-nut (1), then turn the
ring-nut by hand and push the wrench (3) until
it enters the hole of the angle transmission (2),
blocking rotation.
– F it the cutting line head (4) screwing it anti-
clockwise.
– R emove the wrench (3) to restore rotation.
b) Adjusting the guard
– F it the additional guard (8), inserting the cou-
plers into the respective seats in the guard (9)
and pressing until a click is heard.
WARNING! When using the cutting line
head, the additional guard, with line cutting
knife, must always be fitted.
c) Disassembly
- I nsert the supplied wrench (3) in the specific
hole of the inner ring-nut, then turn the ring-nut
by hand and push the wrench (3) until it enters
the hole of the angle transmission (2), block- ing rotation.
– R emove the cutting line head (4) unscrewing
it clockwise.

2. PREPARING TO WORK

2.1 CHECKING THE MACHINE

Before starting work please:
– c heck that all the screws on the machine and
the cutting device are tightly fastened;
– c heck that the cutting device is undamaged
and that the 3 or 4-point metal blades (if fitted)
All manuals and user guides at all-guides.com
– c heck that the air filter is clean;
– c heck that the guards are suited to the cutting
– c heck the handgrips are well fastened.
2.2 FUELS AND OILS
This machine is fitted with a four-stroke engine
which DOES NOT require oil to be added to the
petrol.
IMPORTANT Adding oil to the petrol damages
the engine and will cause invalidation of the war-
ranty.
IMPORTANT Only use quality fuels and oils to
maintain high performance and guarantee the du-
ration of the mechanical parts over time.
2.2.1 Petrol characteristics
Only use unleaded petrol with a fuel grade of at
least 90 N.O.
IMPORTANT Unleaded petrol tends to create de-
posits in the container if preserved for more than 2
months. Always use fresh petrol!
– Keep the petrol in homologated fuel con-
– Never leave the containers within the reach
2.2.2 Oil characteristics
Only use top quality oil specifically for four-
stroke engines, highly detergent, with classifica- tion SF-SG and viscosity SAE10W30.
IMPORTANT The use of a non-detergent or
inadequate oil or one with different features to
those indicated will damage the motor and will
cause invalidation of the warranty
Your dealer can provide you with oils which have
been specifically developed for this type of en-
gine, and which are capable of guaranteeing a
high level of protection and extend the efficiency
of the engine.
2.3 REFUELLING
14
are properly sharpened;
device being used, properly fastened and ef-
ficient;
DANGER! Petrol is flammable!
tainers, in safe place, away from any flames
or heat sources.
of children.