Safety Requirements; Technical Data And Accessories; Safety Regulations - GGP ITALY SBC 425 H Manual De Instrucciones

20. Harness
a. with single belt
b. with double belt
21. Angle transmission
22. Blade protection (for transport)
23. Spark plug
31. Engine stop switch
32. Throttle control
33. Throttle lockout
34. Starter grip
35. Choke
36. Primer
37. Throttle shutter (if provided)
38. Fuel tank cap
The example of the conformity declaration is
found in the penultimate page of the manual.
DESCRIPTION OF EXPLANATORY
SYMBOLS (where applicable)
41. Fuel mixture tank
42. Engine stop switch positions
a = stop
b = running
43. Choke
44. C utting device with adequate protection
45. Cutting device rotation direction

SAFETY REQUIREMENTS

Your machine must be used carefully. Symbols
have therefore been placed on various parts of
the machine to remind you of the main precau-
tions to be taken. Their meaning is explained
below. You are also asked to carefully read the
safety regulations in the specific chapter of this
manual.
Replace damaged or illegible labels.
51. W arning! Danger. The failure to use this ma-
chine correctly can be hazardous for oneself
and others.
52. R ead the instruction manual before using
the machine.
53. A nyone operating the machine under nor-
mal conditions for continuous daily use may
be exposed to a noise level equal to or ex-
ceeding 85 dB (A). Wear ear protectors,
safety goggles and a protective helmet.
54. W ear gloves and protective footwear!
55. P rojectile object hazard! Keep any people
or pets at least 15 m away when using the
machine!
All manuals and user guides at all-guides.com
56. M aximum cutting device speed. Only use
57. D o not use circular saw blades. Danger:
58. Beware of blade thrust.
59. W arning! - The engine emits carbon monox-

TECHNICAL DATA AND ACCESSORIES

[71] Mass
[72] Engine
[73] 4-stroke air-cooled
[74] Capacity / Power
[75] Engine rotation speed when idling
[77] Maximum tool rotation speed
[78] Fuel tank capacity
[79] Oil tank capacity
[80] Spark plug
[81] Fuel
[82] M aximum diameter allowed for blades with
[83] Operator ear noise pressure level
[84] Measurement uncertainty
[85] Measured acoustic power level
[86] V ibrations transmitted to the hand
[87] V ibrations transmitted to the hand
[88] V ibrations transmitted to the hand
[89] V ibrations transmitted to the hand
[90] Guaranteed acoustic power level
[91] Cutting device code
[92] Protection code
[93] Availability:
X = standard machine feature
O = optional, available on request
(–) not provided
1) Read the instructions carefully. Become ac-
quainted with the controls and the proper use
of the machine. Learn how to stop the engine
quickly.
2) Never allow children or people unfamiliar with
these instructions to use the machine. Local
10
suitable cutting devices.
Using circular saw blades with ma-
chines marked with this symbol expos-
es the user to the danger of very serious
or even fatal injuries.
ide. DO NOT start up in an enclosed area.
3 or 4 points
on the front handgrip
on the rear handgrip
on the left handgrip
on the right handgrip

SAFETY REGULATIONS

to be observed scrupulously
A) TRAINING