All manuals and user guides at all-guides.com
Zero mm
Zero mm
(Zero in)
(Zero in)
HANDLEBAR
8. Install:
Start switch 1
G
Master cylinder 2
G
Master cylinder bracket 3
G
Bolt (master cylinder bracket) 4
G
Clamp 5
G
NOTE:
The start switch and master cylinder bracket
G
should be installed according to the dimen-
sions shown.
Install the bracket so that the arrow mark a
G
faces upward.
First tighten the bolt on the upper side of the
G
master cylinder bracket, and then tighten the
bolt on the lower side.
9. Install:
"ENGINE STOP" button 1
G
Clutch lever holder 2
G
Bolt (clutch lever holder) 3
G
Hot starter lever holder 4
G
Bolt (hot starter lever holder) 5
G
Clamp 6
G
NOTE:
The "ENGINE STOP" button, clutch lever
G
holder and clamp should be installed accord-
ing to the dimensions shown.
Pass the "ENGINE STOP" button lead in the
G
middle of the clutch lever holder.
10. Install:
Clutch cable 1
G
Hot starter cable 2
G
NOTE:
Apply the lithium soap base grease on the
clutch cable end and hot starter cable end.
5 - 44
CHAS
9 Nm (0.9 m · kg, 6.5 ft · lb)
4 Nm (0.4 m · kg, 2.9 ft · lb)
4 Nm (0.4 m · kg, 2.9 ft · lb)
Capítulos
