Attaching Rip Fence; Mounting The Table Saw - Bosch 4100 Instrucciones De Funcionamiento

Assembly

Attaching Rip Fence

1. Raise rip fence handle 1, so holding clamp 2 is out far enough to
fit on the table 3 and into "V" groove located on the back of rear
rail (Fig. 14).
2. Position the rip fence 4 over table 3 holding up the front
end, first engage holding clamp 2 with rear rail.
3. Lower front end onto front rail 5.
Mounting The
Table Saw
If table saw is to be used in a permanent location, it should be
fastened securely to a firm supporting surface such as a stand or
workbench, using the four mounting holes 6 (Fig. 15).
1. If mounting to a workbench, the base should be bolted
securely using 5/16" hex bolts (not included) through mounting
holes 6.
Hint: If workbench is 3/4" thick, bolts will have to be at least
3-1/2" long - if workbench is 1-1/2" thick, bolts should be at
least 4-1/2" long.
2. Locate and mark where the saw is to be mounted, relative to
holes in the base of the tool.
3. Drill four (4) 3/8" diameter holes through workbench.
4. Place table saw on workbench aligning holes in base with
holes drilled in workbench.
5. Insert four (4) 5/16" dia. bolts through holes in base and
supporting surface; then secure with (4) 5/16" flat washers and
(4) 5/16" hex nuts.
FIG. 14
2
2
FIG. 15
32.
4
3
3
5
1
1
6