Mounting The Guard For Grinding; Attaching/Removing The Accessory Tool - Parkside PWSAP 20-Li C3 Manual De Instrucciones

NOTE
If the retaining ring
u
groove firmly, rotate the guard for
grinding a few times to displace the
[ ]
retaining ring. You may use a tool (e.g.
pliers, slotted screwdriver) to help (Fig. J).
Rotate the guard for grinding
until the opening of the guard is facing the
product's housing. Pull the tooth of the guard
for grinding out of the receptacle of the
aluminium head.
˜ Mounting the guard for
grinding
Switch the product off. Remove the battery
pack from the product to prevent the
5 ] [
product from starting unintentionally.
With the opening of the guard facing the
product's housing, place the guard for
grinding into the receptacle of the
[ ]
aluminium head. The tooth of the guard must
be aligned with the recess of the receptacle.
Press the guard for grinding
possible into the receptacle. Rotate the guard
for grinding counter-clockwise until it clicks
into place.
Place the retaining ring
the aluminium head to secure the guard for
grinding (Fig. J).
[ ]
Check if the guard for grinding
fixed.
is stuck to the
[ ]
clockwise
[ ]
as far as
[ ]
into the groove of
[ ]
is firmly
[ ]
NOTE
A chuck key is stored inside the
[ 7 ]
u
auxiliary handle
[ 6 ]
used (in addition to the tightening tab) to
loosen or tighten the locking flange
˜ Attaching/removing the
accessory tool
m
WARNING!
Always switch the product off, remove
the battery pack
product cool down before making any
adjustments!
m
CAUTION! RISK OF INJURY!
Keep your hands away from the accessory
u
tool when the product is in operation.
After the product has been switched off, the
u
accessory tool continues moving for some
time. Do not touch the accessory tool and
do not attempt to brake it.
m
WARNING!
Never press the spindle lock button
u
whilst the spindle
The arrow direction on the accessory tool
u
must be aligned with the directional arrow
( or ) .
9 ] [ [ ]
. The chuck key can be
.
[ ]
and let the
5 ] [
1 ] [
is rotating!
[ ]
GB/IE 53