Parkside PWSAP 20-Li C3 Manual De Instrucciones página 57

˜ Wire brushing
m
WARNING!
Do not use a brush that is damaged, or
u
which is out of balance. Use of a damaged
brush could increase potential for injury
from contact with broken brush wires.
Avoid applying too much pressure which
causes over bending of wires, leading to
premature breakage.
Work with moderate feed, suited to the
material being worked.
Avoid bouncing and snagging the wire brush,
especially when working corners, sharp
edges etc. This can cause loss of control and
kick-back.
˜ Abrasive cutting
m
WARNING!
Never use grinding discs for cutting!
u
When using a cutting disc, the guard for
cutting must be used when operating
[ ]
the power tool.
Only use tested, fibre reinforced cutting discs.
Always work at a low forward speed. Apply
only moderate pressure to the workpiece.
Always use up (conventional) milling. This
will prevent loss of the product when it leaves
the cut.
56 GB/IE
˜ Cleaning and care
m
WARNING!
Always switch the product off, remove
the battery pack
product cool down before performing
inspection, maintenance and cleaning
work!
˜ Cleaning
Never allow fluids to get into the product.
The product must always be kept clean, dry
and free from oil or grease. Remove debris
from it after each use and before storage.
Regular and proper cleaning will help ensure
safe use and prolong the life of the product.
Clean the product with a dry cloth. Use a soft
brush for areas that are hard to reach.
In particular clean the air vents after every
use with a cloth and soft brush.
The vents must always be clear.
NOTE
Do not use chemical, alkaline, abrasive or
u
other aggressive detergents or disinfectants
to clean this product as they might be
harmful to its surfaces.
and let the
5 ] [