Kalor SLIM IDRO 16 Manual Del Usuario página 99

Shutting the thermostove down
In the period when the thermostove is out of
use it must be disconnected from the electricity
mains. For greater safety, especially if there are
children around, we recommend removing the
power cable from the rear of the thermostove.
Before placing the thermostove in storage, you
should remove all pellets from the hopper with
a vacuum cleaner with a long extension. If the
fuel is left in the hopper, it may get damp, stick
together, and be dif cult to light at the beginning
of the next season.
If pressing the main switch (located on the back
of the stove) does not make the control panel
display light up, it could mean that the service
fuse needs replacing.
On the rear of the stove there is a fuse holding
compartment which is located underneath the
supply socket. With a screwdriver open the
cover of the fuse holding compartment, and
replace the fuse if necessary (3,15 AT delayed
type). Plug the unit back in and press the main
switch.
CLEANING BY THE TECHNICAL
Check every year
Compartment ventilation ue gas cleaning
Remove the xing screws and remove the
smoke fan for cleaning of the same. Perform the
task with the greatest care not to bend the fan
blades.
Clean ue
Clean the ue system especially near the ttings
to "T", curves and any horizontal sections. Is
necessary to check and remove any deposit
of ash and soot before the same clogging the
passage of smoke.
Cleaning the exchanger
Lift the top of the thermostove where present
the entire top. Otherwise, open the fuel ller ap
pellet (on the right side of the thermostove) and
the door smoke (on the left side). Then unscrew
the four screws that secure the display to enter
the tube bundle.
Then unscrew the 10 screws on the cover and
the two items above the door and hidden from
the front panel.
99