Kalor SLIM IDRO 16 Manual Del Usuario página 98

Cleaning exchanger - stove off
Fouling act as insulation and the thicker they
are, the lower the heat that is transmitted to the
water and to the structure
very important to perform the cleaning of the
tube bundle, said exchanger also, to prevent the
fouling of the same and prevent clogging and
jamming of the cleaning
quickly for 5-6 times the lever so that the springs
can remove the soot deposited on the pipes.
Check every 2/3 days
Cleaning the ash collection compartment.
Clean and empty the ash tray being careful with
hot ash. The ash must be completely cold for a
vacuum cleaner to be used to remove it. Only if
the ash is completely cold, you can also use a
canister vacuum cleaner suitable for picking up
particles of a certain size.
Cleaning ash and combustion chamber
including the spark plug lead
Cleaning the glass
For cleaning the ceramic glass, the use of a dry
brush is recommended, or if it is very dirty, the
special spray detergent, applying a small quantity
then cleaning with a cloth.
Do not use abrasive products and
do not spray the cleaning product
on the glass of the painted parts
or on the gaskets of the re door
(ceramic bre cord).
98
generally. Therefore
device. Pull and push
Cleaning of stainless steel and satin- nish
surfaces
Normally these surfaces do not need to be
treated, but if they do, avoid cleaning them with
abrasive materials. For surfaces in stainless and
satin brushed steel we recommend cleaning with
a paper towel or a clean dry cloth moistened
with a detergent based on non-ionic surfactants
(<5%) A spray glass cleaner may be used.
Avoid contact with skin cleanser
and eyes. In case this happens,
sprinkle with plenty of water and
contact the nearest medial center.
Cleaning of painted pats
Do not clean the painted parts with wet rags when
the unit is in operation or hot to prevent thermal
shock to the paint which may cause it to detach.
Do not use abrasive or aggressive products
or materials. Clean with damp cotton or paper
towels. The silicon paints used by manufacturer
possess technical characteristics that make
them resistent to very high temperatures.
There is however a physical limit (380° - 400°)
beyond which the paint begins to fade or (over
450°) to vitrify; it may then ake and detach from
the steel surface. If this happens, it means that
temperatures have been reached that are far
above those at which the unit should operate
properly.
Do not use abrasive materials or
harsh. Clean with damp cotton or
paper towels.
Clean bottom ash from the fallen debris during
operation. You can access the ash pan by
loosening the two wing nuts that hold the drawer
inspection. Remove the tray, empty and clean
the wall and only the corners with a suction
device or with dedicated
the drawer and tighten the two knobs being
careful to restore the tightness, very important
during operation.
With a dry clean also the combustion chamber.
tooling. Then mount