Directions For Use; Flushing The System - Kalor SLIM IDRO 16 Manual Del Usuario

Directions for use

If the installation of the thermostove provides
interaction with another
complete with a heater (gas boiler, gas boiler, oil
boiler, etc.) consult quali ed personnel who can
then answer the compliance of the system, as
envisaged by the law in force.

Flushing the system

In accordance with the UNI-CTI 8065 is
strongly recommended to wash the entire
system before connecting it in order to get
rid of residues and deposits. After
the system to protect it against corrosion and
deposits, it is recommended the use of inhibitors.
Upstream from the stove, always install shutters
so as to disconnect it from the plumbing system
should it be necessary to move it, or when it
requires routine and/or special maintenance.
Connect the stove using hoses so that the stove
is not too strictly connected to the system, and
to allow slighht movement. These are as helpful
as the supply and return piping system if the
heating system is on a higher
boiler.
The exhaust pipe pressure is connected
temporarily to a carafe or a funnel to avoid,
in case of overpressure, that the water gush
bathrooms and the structure and the oor.
Replenishment of the System
The replenishment has to be slowly carried out
existing system
in order to let the air bubbles ow out through
the right oulets that are placed on the heating
system. In heating systems with a closed circuit
the loading cold pressure of the system and the
in ation pressure of the expanding vase must
correspond.
• in heating systems with open vase, the direct
contact between the circulating liquid and the
air is allowed. During the heating-season the
user must regularly check the circulating water
level in the expansion vase.
ushing
The content of water in the system of recirculation
must be stable hold.
Experiences show that the user must regularly
check the water level every 14 days in order to
maintain a stable water content.
The replenishment process must be carried out
in case of necessity of more water when the
thermostove has cooled down.
These preventive measures aim to prevent the
insurgence of thermic stress of the steel body of
the thermostove.
oor than the
• in systems with open vase, the pressure of
water in thermostove, when the system is cold,
mustn't be lower than 0,3 bar;
• the water used to ll up the heating system
must be decontaminate and without air.
SAFE TY
VALVE
Once all the water connections, proceed to
check pressure seal by lling the thermostove.
You must not mix
heating system with antifreeze or
anticorrosion substances in wrong
concentrations. This could ruin the
seals and provoke the insurgence
of noises while operating. The producer
refuses any responsibility for damages
towards persons, animals or things if this
warning will not be respected.
water of the
69