Troubleshooting - Reer BABYPHON NEO Manual Del Usuario

NOTE:
Should the baby (transmitter) or parent
unit (receiver) not be functioning
properly or should unexpected malfunc-
tioning occur, we kindly ask you to :
1.) once again first thoroughly read the
respective section of the instruction
manual.
2.) Afterwards please try to find the
error with the help of the following mal-
function chart.
3.) Should you not be able to solve the
problem, we kindly ask you to contact
your specialist dealer or to call our
hotline at +49 (0)700 /73 374 624.
ATTENTION:
Under no circumstances should
you try to repair the devices on
your own because that would
lead to the expiration of the
warranty.
All manuals and user guides at all-guides.com

Troubleshooting

Before using the device for the first time, please check the functional efficiency (e.g. with the help of a tele-
vision). Now please carry out the fine adjustment (sensitivity of the baby unit, volume of the parent unit) and
make sure that an ideal transmission is ensured. When doing so, please take into consideration that a farther
distance and thick walls can have a negative influence on the quality of the transmission.
Problem / Situation
Status LED is off
The receiver is not recei-
ving any signals and the
green LED next to the 4
red LEDs is blinking
Battery indicator is lit up
Hissing or peeping
sounds
Electrostatic hissing
possible malfunction source What can be done?
* The device is turned off * Check if the device is set to
* The batteries are empty channel A or B
* The power adapter is not * If the device is connected to a
connected power adapter, make sure that
* Power failure it is connected properly
and that the power outlet is
functioning
* Check if the batteries are
charged or if the batteries
are in the correct + / - position
or if the batteries' contacts are
dirty/rusty
* The transmitter is not * If the green LED next to the 4
transmitting any signals red LEDs is blinking (receiver),
the transmitter is not receiving
any sounds and transmitter as
well as receiver go into stand-
by mode
* The batteries are weak * Replace the batteries or use
the power adapter
* The devices are too close * Place both devices farther
together apart
* The volume is turned up * Reduce the volume
too high
* The disturbances are * Determine which device is
caused by other devices causing the disturbance and
in the home e.g. cordless remove it from the area of the
telephones, computers, baby monitor
mobile phones etc.
page 15