Power Supply Baby And Parent Unit - Reer BABYPHON NEO Manual Del Usuario

Power supply baby and parent unit

Both devices can be operated either with batteries or using the mains supply.
Choose a suitable type of operation.
Batterys
02. inserting the batteries
Insert the batteries (3 pieces; type AAA in receiver and 4 pieces;
type AAA in sender) into the battery compartment. Please al-
ways pay attention to the correct polarity according to the pola-
rity information + and – indicated in the battery compartment.
Use of the power adapters included in delivery
2. Connect the power adapters to a power outlet
Connect the power adapters to a power outlet. (ATTENTION:
Choose a suitable power outlet for the baby unit which is si-
tuated as far away from your child as possible. Please make
sure that the indicated voltage of the devices corresponds to
the local power supply voltage.)
Note:
Each time you replace the batteries, please check the functioning of the devices afterwards. As soon as you switch
on the device, the status-LED should indicate a green light.
page 12
All manuals and user guides at all-guides.com
01. Opening the battery compartments' covers
Thus, please un-tighten the screw at the battery compartment
and pull the cover at the underside upwards.
03. Closing the battery compartments' covers
After inserting the batteries please snap the compartment cover
back into place and hand-tighten the safety screw.
01. Connect the power adapters
Connect the power adapters included in delivery to the devices'
power supply sockets.
ATTENTION:
Turn off the devices before you
replace empty batteries
Both devices, i.e. the parent as
well as the baby unit, can be
operated with standard non-re-
chargeable AAA 1,5V batteries or
with AAA rechargeable batteries.
Please always make sure that
you use batteries of the same
type. When using rechargeable
batteries, these must be charged
outside of the device.
ATTENTION:
Please make sure that the
indicated voltage of the devices
corresponds to the local power
supply voltage.