Cleaning And Maintenance; Troubleshooting - Reer BeeConnect Instrucciones De Uso

Cleaning and maintenance

Always disconnect the mains adapters from the wall power socket before
cleaning the unit. Only use a slightly dampened cloth. Do not submerge the
unit in water. Do not use chemical detergents.
Remove the batteries from the unit if it is not to be used for a long period
of time.
This product does not require any special maintenance. Repairs to the unit
must be carried out by skilled personnel only.

Troubleshooting

Problem
The status LED does not
light up
Status LED flashes green
when device is switched on
Status LED flashes red
when device is switched on
and signal tone sounds.
Status LED flashes red
green when device is
switched off
No connection, Status LED
alternately flashes red and
green when switched on,
with signal tone
No sound transmission des-
pite established connection
Loud whistling sound
(acoustic feedback)
24
Possible cause
• The unit is not switched on.
• The mains adapter of the transmitter/recei-
ver is not (properly) connected or the power
socket is not working.
• The batteries are flat/incorrectly inserted.
• Power adapter is connected and the batte-
ries are charging in the unit.
• Batteries are flat.
• Batteries are charging.
• The maximum range has been exceeded.
• The baby unit is not switched on.
• Baby monitor is in ECO mode and baby unit is
in sleep mode (and thus does not transmit any
signals to the parent unit).
• Volume is switched off.
• The selected/set microphone sensitivity level
is too low.
• The baby unit is too close to the parent unit.
Action
• Make sure that both units are switched on.
• Check the connection of the mains adapter to
the wall power socket and the unit.
• Replace/charge the batteries and check their
polarity.
• No action required.
• Replace/charge the batteries or connect the
unit to the power supply.
• No action required.
• Reduce the distance between the baby unit
and the parent unit.
• Ensure that the baby unit is switched on.
• Briefly set the baby unit to "range alarm" until
the connection has been established or force
a signal transfer by making noises at the baby
unit.
• Ensure that the volume has not been turned
down all the way, press the key on the
parent unit several times.
• Switch the microphone sensitivity to "HI".
• Increase the distance between the baby unit
and the parent unit.