Troubleshooting - Reer Rigi 400 Manual De Uso

Troubleshooting

The status LED does not light up
Make sure that both units are switched on.

Check the connection of the mains adapter to the wall power socket and the unit.

Exchange the batteries and/or check the polarity.

Check the channel setting (A or B) of the transmitter and receiver.

The status LED flashes orange
The parent unit receives sounds. Turn up the volume on the parent unit to make sure

that you hear the sounds from your baby.
The status LED flashes red
Long flashing: Batteries are flat. Replace the batteries or connect the unit to the power

supply.
Short flashing: maximum range is exceeded. Reduce the distance between the baby and

parent unit.
No sound transmission despite established connection
The volume is set too low. Turn the volume control on the parent unit up.

The microphone sensitivity is set too low. Turn the microphone sensitivity control on the

baby unit up.
You can hear other wireless devices
As this baby monitor works with analogue radio technology, interference from other

wireless devices can occur. Change the channel.
22