Checks After Care And Maintenance Work - Hilti GX 2 Manual De Instrucciones

▶ Check all external parts of the fastening tool regularly for damage and make sure that
all operating controls function faultlessly.
▶ Do not use the fastening tool if parts are damaged or if operating controls do not
function faultlessly.
▶ Have a defective fastening tool repaired by Hilti Service.

10.4 Checks after care and maintenance work

▶ After maintenance, check that the fastener guide is fitted → page 10.
11 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy
the problem by yourself, please contact Hilti Service.
Malfunction
Fasteners are frequently
driven to inadequate
depth.
Fasteners are frequently
driven too deeply.
Fasteners break.
Fasteners bend.
12
Possible cause
Driving power is too low.
The fasteners are too long.
The supporting material is
too hard.
Driving power is too high.
The fasteners are too short.
Driving power is too low.
The fasteners are too long.
The supporting material is
too hard.
The fastener guide is not
held perpendicular to the
working surface.
Driving power is too low.
The fasteners are too long.
Action to be taken
▶ Move the fastener driving
depth adjustment slider to
the «+» position.
▶ Use shorter fasteners.
▶ Consider using a DX
fastening tool.
▶ Move the fastener driving
depth adjustment slider to
the «‒» position.
▶ Use longer fasteners.
▶ Move the fastener driving
depth adjustment slider to
the «+» position.
▶ Use shorter fasteners.
▶ Consider using a DX
fastening tool.
▶ Use the support leg on an
even surface and make
sure that it's in contact
with the surface (see
support leg → page 6).
▶ Press the nose of the tool
against the working sur-
face, keeping the fastener
guide perpendicular to the
surface (see driving nails,
→ page 8).
▶ Move the fastener driving
depth adjustment slider to
the «+» position.
▶ Use shorter fasteners.