Unloading The Magazine; Checking The Status Of The Gas Can; Removing The Magazine - Hilti GX 2 Manual De Instrucciones

Note
It is not possible to drive a fastener if the fastening tool is not pressed fully
against the working surface.
6. Lift the fastening tool completely away from the working surface after driving a
fastener.
7. Remove the gas can ( → page 9) and battery ( → page 9) and empty the magazine
( → page 9) when work with the fastening tool is finished or before leaving the tool
unattended.
7 Unloading the fastening tool
7.1 Removing the battery
▶ Press both battery release buttons at the same time and pull the battery out of the
fastening tool.
7.2 Removing the gas can
1. Open the gas can compartment.
2. Remove the gas can.
3. Close the gas can compartment.

7.3 Unloading the magazine

1. Pull the nail pusher back until it engages.
2. Remove all nail strips from the magazine.
WARNING
Risk of finger injury! Fingers could be pinched when the nail pusher is released.
▶ When disengaging the nail pusher, do not release it and allow it to jump forward.
Guide it forward slowly as far as it will go.
3. Release the nail pusher and guide it forward as far as it will go.
8 Optional operating steps
8.1 Removing the transport safety device from a new gas can
1. Lift the transport safety device, containing the metering valve, away from the gas can.
2. Remove the metering valve from the transport safety device.
3. Fit the metering valve onto the gas can, with the foremost of the two grooves on the
lip of the can.
4. Press the metering valve firmly onto the gas can, bringing the rearmost groove towards
the lip of the can, until the metering valve is heard to snap into place over the lip and
it then lies flush with the can.

8.2 Checking the status of the gas can

1. After inserting the battery, press the ‚GAS' button without pressing the fastening tool
against the working surface.
2. Read the gas can status from the display. → page 6

8.3 Removing the magazine

1. Pull the nail pusher back until it engages.
2
9