Tabla de contenido
Idiomas disponibles
Idiomas disponibles
TROUBLE
Saw will not start
Battery not installed
Battery not charged
Brushes worn out
Saw makes unsatisfactory
Dull blade
cuts
Blade mounted backwards
Gum or pitch on blade
Incorrect blade for work being done
XPS™ worklight is flashing
Battery not charged
Machine vibrates
Saw not mounted securely to stand or work bench
excessively
Stand or bench on uneven floor
Damaged saw blade
Does not make accurate
Mitre scale not adjusted correctly
mitre cuts
Blade is not square to fence
Blade is not perpendicular to table
Workpiece moving
Kerf plate worn or damaged
Material pinches blade
Cutting bowed material
Troubleshooting Guide
BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
WHAT's WROnG?
WHAT TO DO
Install battery. Refer to Installing and Removing Battery Pack.
Charge battery. Refer to Charging Procedure.
Have brushes replaced by authorised service centre.
Replace blade. Refer to Changing or Installing a New Saw Blade.
Turn blade around. Refer to Changing or Installing a New Saw Blade.
Remove blade and clean with coarse steel wool and turpentine or household oven cleaner.
Change the blade type. Refer to Saw Blades under Optional Accessories.
Charge battery. Refer to Charging Procedure.
Tighten all mounting hardware. Refer to Bench Mounting.
Reposition on flat level surface. Refer to Familiarization.
Replace blade. Refer to Changing or Installing a New Saw Blade.
Check and adjust. Refer to Mitre Scale Adjustment under Adjustments.
Check and adjust. Refer to Mitre Scale Adjustment under Adjustments.
Check and adjust fence. Refer to Bevel Square to Table Adjustment under Adjustments.
Clamp workpiece securely to fence or glue 120 grit sandpaper to fence with rubber cement.
Take to authorised service centre.
Refer to Bowed Material under Special Cuts.
EnGLIsH
49
Tabla de contenido
Solución de problemas
