Technical Information; Legal Requirements; Installation - F.Bertazzoni F45 CONXT Manual De Mantenimiento E Instalación

3172533-000 english-1st IT.qxd:-

Technical Information

If the equipment does not work, please
contact the Technical Service Department and
advise them of the problem, indicating:
1 Serial number (S-No)
2 Appliance model. (Model)
You will find this information on the rating
plate on the lower part of the oven when the
door is opened.
The item that you have bought meets the
European directives on electrical material
safety (73/23/CEE) and electromagnetic com-
patibility (89/336/CEE).

Installation

This information is intended for the installer,
as the person responsible for assembly and
electrical connection. If you install the oven
yourself, the manufacturer will not be held
responsible for any possible damage.
Installation must only be performed by a fully
qualified electrician
regulations laid down for installation are
observed.
Before Installation. Comments
• To unpack the oven, pull the tab located on
the lower part of the box.
• A niche is required in the kitchen unit as per
the dimensions shown on the figure,
providing a minimum depth of 580 mm.
(See figure 1 describing oven fitting on the
page 14).
12
16/3/12
who must ensure
08:06 Página 12
• To fit multifunction ovens in their locations,
the back part of the unit corresponding to
the shaded area of figure 1, must not have
any projections (reinforcements, pipes,
sockets, etc). (See the page 14).
• The adhesive used for the plastic covering
of kitchen furniture must be able to
withstand temperatures up to 85ºC.
Electrical Connection.

Legal Requirements

The installer must check that:
• The voltage and cycles of the mains supply
correspond to that indicated on the rating
plate.
• The electrical installation can stand the
maximum power indicated on the rating
plate.
• The connection diagram is shown in the
following figure:
• The electrical connection has adequate
earthing in accordance with regulations in
force.
• The connection must be carried out with an
omnipolar switch, of an adequate size for
the current drawn. There must be a
minimum aperture between contacts of 3
mm to enable disconnection in the case of
emergency, cleaning or bulb exchange.