Timberland VR42 Manual De Instrucciones página 3

Size: 170 x 55mm
Color: Blk
Power depletion warning function
When the energy stored in the secondary battery is reduced to an extremely low level, the
second hand starts moving at two-second intervals instead of the normal one-second intervals.
In that case, recharge the watch as soon as possible by exposing it to light. Otherwise, the
watch may stop operating in about 2 weeks.
How to charge and start the watch
* Charging the watch
When you start the watch or when the energy remaining in the secondary battery is very low,
charge it sufficiently by exposing the watch to light.
(1) Expose the watch to sunlight or strong artificial light (of more than 1,000 Lx).
When the watch has stopped operating, the second hand will start moving at two-second intervals.
- The second hand immediately starts moving at two-second intervals, but the energy stored in the
secondary battery is not yet sufficient. If the watch is turned away from the light, it may stop
operating.
It is not necessary to charge the watch fully. It is important, however, to charge the watch
sufficiently, especially in the case of initial charging.
(2) Keep the watch exposed to the light until the second hand moves at one-second intervals.
(3) When the watch is charged after it has completely stopped, set the date and time before
wearing the watch.
Size: 170 x 55mm
Color: Blk
Guidelines for charging time
The below table provides only general guidelines.
Illumination A
Source of light Environment
(Lx) (Approx. Hours)
700 Inside the office -
A fluorescent lamp
52
3,000 30W 20cm
10,000 Cloudy 16
Sunlight
100,000 Fine weather 5.3
Condition A : Time required for full charge
Condition B : Time required for steady operation
Condition C : Time required for 1 day's charge
(*) The values in this column represent the charging times required until the second hand moves constantly
at one-second intervals after the watch starts operating with the second hand moving at two-second
intervals. Even if the watch is not charged for the time specified in the column, the second hand may
temporarily move at one- second intervals. But it will soon resume moving at two-second intervals;
therefore, charge the watch for more than the specified period.
* Caution
When charging the watch, do not place it too close to fluorescent lamp or other light sources as
the watch temperature will become extremely high, causing damage to the parts inside the watch.
* To prevent energy depletion
• Avoid covering the watch face with your clothing while wearing it.
• When the watch is not in use, leave it in a brightly lit place for as long as possible. Make sure
that the watch temperature does not exceed 50°C.
How to use stopwatch function
• The stopwatch can measure up to 29'59'' in one-second increments.
• When the measurement reaches 30 minutes, the stopwatch automatically stops counting.
(Dial transparency rate is 30%)
Standard measurement
B (*) C
(Approx. Hours) (Approx. Minutes)
Button A
18 69
Start
Accumulated elapsed time measurement
4 15
Button A
1.5 5
Start
0.5 2
Split time measurement
Button A
Start
Measurement and release of sprit time
can be repeated by pressing the button B.
Measurement of two competitors
Button A
Start Finish time of
1st competitor
Button A Button B
Stop Reset
Button A Button A Button A Button B
Stop Restart Stop Reset
Restart and stop of the stopwatch
can be repeated by pressing the button A.
Button B Button B Button A Button B
Split Split release Stop Reset
Button B Button A Button B Button B
2nd competitor Finish time of Reset
finishes 2nd competitor