Initial Operation; Setup; Accessing The Web Application Via The Hotspot - Porsche Home Energy Manager 9Y0.915.686 Manual De Instalación

Checking the signal quality of the PLC network
Information
The software and Ethernet PLC converter described
in this section are not in the scope of delivery.
To check the connection quality of the PLC network,
you can find out the PLC transmission rate via the
household electrical system using software and
Ethernet PLC converters. To do this, connect the
converters to the mains supply at the installation
locations.
Select the installation location of the energy manager
and of the current consumers with PLC functionality
(such as Porsche Mobile Charger Connect) as
installation locations for this.
The actual transmission rate between the installation
locations can be displayed with the aid of evaluation
software. Transmission rates of 100 Mbit or more are
sufficient.

Initial Operation

When the power supply is on, the energy manager is
switched on and ready for operation:
On/Off status lights up green.
To ensure the energy manager functions reliably and
with its full range of functions, the latest software
must be installed.
e After startup, perform a software update using
the web application.

Setup

The energy manager is set up via a web application.
On this web application, all the necessary values can
be entered and the current sensors configured.
Charging equipment that supports this function can
be added as an EEBus device.
The following information may be required to set up
the energy manager:
– Access data for the home network
– Access data for the user profile (for linking to the
Porsche ID)
– Information on electricity tariffs/prices
Accessing the web application via
the hotspot
The web application can be opened on a device (PC,
tablet or smartphone) via a hotspot established by
the energy manager.
e To open the web application when the hotspot
has been enabled, enter the following IP address
in the address bar of the browser: 192.168.9.11
Information
– Depending on which browser you are using, the
web application will not open immediately, but
information about the browser's security settings
will be displayed first.
– You need to enter the network key to open the
web application, but how you do this depends on
your device's operating system.
Logging on to the web application
Two users are available for logging on to the web
application: H and C
OME USER USTOMER SERVICE
e To set up the energy manager, log on to
the energy manager web application as
C . The initial passwords can be
USTOMER SERVICE
found in the access data letter.
Fig. 15: Energy manager web application (O
P
A
OWER SOURCES
C
B
URRENT FLOW
C
C
URRENT CONSUMER
E
D
NERGY
Initial Operation
DE
EN
.
FR
IT
ES
PT
NL
SV
FI
DA
NO
EL
CZ
HU
)
VERVIEW
PL
HR
SR
SK
SL
ET
LT
LV
RO
BG
MK
27