Starting The Engine; Driving - Jacobsen CG2 Serie Manual De Seguridad, Funcionamiento Y Mantenimiento

7 OPERATION
9. Slow down and use extra care on hillsides. Read Section 3.7. Use caution when operating near drop
off points.
10. Never use your hands to clean cutting units. Use a brush to remove grass clippings from blades. Blades
are extremely sharp and can cause serious injuries
OPERATION OF THE
MACHINE
Read the Safety Instructions.
BEFORE OPERATING FOR THE FIRST TIME
• Check and adjust tyre pressure, if
necessary, to 1 kg/cm
• Add diesel fuel to tank if neccesary.
• Check engine oil and top-up, if necessary.
• Check radiator coolant and top-up, if
necessary (50% antifreeze solution).
• Make sure you understand the information
contained in the previous sections.
7.4

STARTING THE ENGINE

The following procedure is for starting cold engines.
1. Ensure the FWD/REV pedal is in the neutral
position, the mow switch is off, the throttle
setting is in a mid position and the parking
brake is applied.
2. Turn the ignition switch to position No.2 and
hold until the glow plug light goes off (5-10
sec.)
3. Turn ignition key fully clockwise to the start
position and operate the starter motor until
the engine starts (This should only take a
few seconds)
4. When the engine starts, release the key
immediately and it will return to the RUN
position.
5. If the engine does not start, preheat the
glow plugs and try again.
en-24
SAFETY AND OPERATION & MAINTENANCE MANUAL
WARNING
DO NOT USE ON SLOPES GREATER THAN
15°
2
(14 psi).
JACOBSEN FAIRWAY 305 Series CG2
NOTES:
Warm engine - When the engine is warm
•
because of surrounding temperature or
recent operation, step No.2 of the cold
engine starting procedure may be skipped
(no need to preheat glow plugs).
• If the engine fails to start after two tries (with
preheat if necessary), wait 20 seconds and
try again.
• The starter motor should never be run
continuously for longer than 30 seconds or
it may fail.
7.5

DRIVING

Release brake - Make sure the parking
•
brake is released before attempting to go
forward or reverse.
Forward - Gently depress the top plate of
•
the FWD/REV foot pedal to reach desired
ground speed.
Reverse - Gently depress the bottom plate
•
of the FWD/REV foot pedal to reach desired
ground speed.
To stop - Gently return the FWD/REV foot
•
pedal to the neutral position.
NOTES:
• Use complete foot to operate both forward
and reverse.
• Do not move pedal suddenly–always
operate slowly and smoothly. Never move
pedal violently from forward to reverse or
vice versa.
• Always keep foot firmly on the foot pedal–
a too relaxed foot control may result in a
jerky motion.