Optional Programming - Nice Neomat A Instrucciones Y Advertencias Para La Instalación Y El Uso

4.3) Optional programming

All optional programming is only possible after the "0" and "1" positions have been programmed.
4.3.1) Memorisation of the intermediate position "I"
If an intermediate positions "I" has been memorised, the shutter can be manoeuvred into the programmed position by pushing the t and s
buttons of the transmitter together. Proceed as follows to memorise the intermediate positions:
Table "A6" Programming of the intermediate position "I"
Move the shutter into the desired intermediate position "I" by means of the s ■ t
1.
buttons of a remote control
Keep the ■ button pushed until a beep is heard (after about 5 seconds)
2.
Release the ■ button and push it again for another 5 seconds until 4 rapid beeps are heard
3.
Push the t s buttons together until 3 beeps signal that the position has been memorised
4.
4.3.2) Cancellation of the memorised position
In order to modify the memorised positions, they must firstly be cancelled and then the new positions programmed again.
Table "A7" Cancellation of the intermediate position "I"
Push and hold the ■ button of an already memorised transmitter until a beep is heard
1.
(after about 5 seconds)
Release the ■ button and push it again for another 5 seconds until 4 rapid beeps are heard
2.
Push the s t buttons together until 5 beeps signal that the intermediate position has
3.
been cancelled
Now the new intermediate position can be programmed (Table "A6")
Table "A8" Cancellation of the "0" and "1" positions
Push and hold the ■ button of an already memorised transmitter until a beep is heard
1.
(after about 5 seconds)
Release the ■ button and push it again for another 5 seconds until 4 rapid beeps are heard
2.
Push the s button (if the automatic or manual programming has been performed) or the t
3.
button (if the semi-automatic programming has been performed), until 5 beeps signal that
the "0" and "1" positions have been cancelled
WARNING: After having cancelled the "0" and "1" positions the shutter will move in the hold-to-run mode and the new positions need to be
memorised (Tables "A3", "A4", "A5")
Example
5s
5s
Example
5s
5s
Example
5s
5s
6