Optional Programming - Nice neomat A Instrucciones Y Advertencias Para El Instalador

4.3) Optional programming

Optional programming operations can only be performed after the "0" and "1" positions have been programmed
Programming the intermediate position "I"
If an intermediate position "I" has been memorised, the shutter can be moved to the programmed position by simultaneously pressing keys
and on the transmitter.
To memorize the intermediate position proceed as follows:
Table "A6" Programming the intermediate position "I" (fig 12)
1. Using keys
to memorise as "I"
2. Press and hold down (approx. 5 seconds) key
3. Release and then press again key
4. Press keys
memorised
4.4) Modifying the memorised positions
To modify the memorised positions, first you need to erase them, then you must reprogram the new positions.
Table "A7" Erasing intermediate position "I" (fig 12)
1. Press and hold down key
(approx. 5 seconds)
2. Release and then press again key
3. Press keys
has been erased
It will now be possible to programme the new intermediate position (Table "A6")
Table "A8" Erasing positions "0" and "1" (fig 13)
1. Press and hold down key
(approx. 5 seconds)
2. Release and then press again key
3. Press either the
key (if semiautomatic programming has been carried out), until you hear 5 beeps.
This indicates that positions "0" and "1" have been deleted.
WARNING: After positions "0" and "1" have been erased, the shutter will only move by manual control, therefore a new position must be
memorised (Tables "A3", "A4", "A5")
If you need to erase all the data contained in the memory of the NEOMAT control unit, carry out the following procedure.
The memory can be erased:
• with a non-memorised transmitter starting from point A.
• with a previously memorised transmitter starting the procedure from point N°1
The following can be erased:
• only the transmitter codes, finishing at point N°4
• all the data (transmitter codes, positions, wind levels, TTBUS address, etc.), completing the procedure.
Table "A9" Erasing the memory (fig 14)
A. Switch the motor off, activate the Step-by-Step input (by connecting up the white and black
wires)and keep it active until the end of the procedure
B. Power the motor and wait for the 2 initial beeps
1. Press and hold down key
(approx. 5 seconds)
2. Press and hold down key
during the third beep.
3. Press and hold down key
during the third beep
4. Press and hold down key
during the third beep
5. If you wish to erase all the data, press the
release them
After a few seconds 5 beeps will signal that all the memorised codes have been erased.
6
on a remote control, move the shutter to the position that you wish
for 5 more seconds until you hear 4 short beeps
and simultaneously until 3 beeps signal that the position has been
on a previously memorised transmitter until you hear a beep
for 5 more seconds until you hear 4 short beeps
and simultaneously until 5 beeps signal that the intermediate position
on a previously memorised transmitter until you hear a beep
for 5 more seconds until you hear 4 short beeps
key (if automatic or manual programming has been carried out) or the
on a previously memorised transmitter until you hear a beep
on the transmitter until you hear 3 beeps; release key
on the transmitter until you hear 3 beeps; release key
on the transmitter until you hear 3 beeps; release key
until you hear the beep
and keys together within 2 seconds and then
Example
Example
Example
Example
PP
exactly
exactly
exactly
within 2s
5s
5s
5s
5s
5s
5s
5s
5s