Nice Neomat A Instrucciones Y Advertencias Para La Instalación Y El Uso página 4

2.1.4) "F210S Photocell" input (White + Black/White) (For NEOMAT-MA and NEOMAT-LA versions only):
The specific F210S photocell can be connected to the "F210S photocell" input that detects possible obstacles preventing the lowering
manoeuvre. See the F210S photocell instructions manual for further information concerning connections.
The transmitter must be memorised before the photocells are connected if the F210S photocells are to be used.
The Step-by-Step, TTBUS and F210S inputs are alternative one to the other because each uses the same White +
Black/White wires, therefore one type of input can be used at a time.
2.1.5) Weather sensors (Black/White + Orange/White):
A simple wind sensor (anemometer) or a wind-sun-rain special sensor can be connected to the "Weather sensors" input between the Com-
mon and the Weather sensors input. The same sensor can be connected up to 5 control units, which are all connected in parallel. It is essen-
tial that the polarity is respected: on all motors, the Black/White wire is connected to the Black/White wire and the Orange/White wire is con-
nected to the Orange/White wire.
2.1.6) Resistive sensitive edge input (Black/White + Orange/White):
A sensitive edge with an 8.2KΩ constant resistance can be connected.
See paragraph 4.3.3 for the programming and operation in the event the resistive edge is activated
The weather sensor and resistive edge inputs are alternative to one another because they use the same Black/White
+ Orange/White conductor therefore only one type of input can be used at a time.
2.2) Cable output direction
(this chapter concerns the NEOMAT-LA version only).
If it is necessary to change the cable output direction, simply:
1. Pull the protection outwards.
2. Bend the cable in the required direction.
3. Introduce the protection, making sure that it is securely pushed
into its location.
2.3) Power supply cable and connector
only).
If the power cord is damaged it must be replaced with an identical type supplied by the manufacturer or an autho-
rised customer service centre.
If it is necessary to disconnect the motor from the power supply cable proceed as shown in the figures below:
Turn the ring nut until the bevel
coincides with one of the connect-
ing teeth, and then disconnect.
3
(this chapter is intended for NEOMAT-MA version and technical assistance personnel
Repeat the same operation for
the other tooth.
Bend the cable inwards and
remove the protection by turning
it carefully outwards.
Pull out the connector.