Using The Blind Spot Assistant - Dometic MAGICWATCH MWE 4004 Instrucciones De Montaje Y De Uso

MWE4004
Setting the sensitivity of the sensors
➤ Press the "SENS" button briefly to switch to the sensitivity.
The sensitivity switches in the order "Low – Medium – High – Low ...".
✓ The LED display acknowledges the selected sensitivity with an acoustic signal:
– a short beep: low
– two short beeps: medium (default setting)
– three short beeps: High
Setting the siren or camera
➤ Press the "SENS" button for approx. 3 s.
✓ The LED display acknowledges whether you have configured a siren or a camera
with an acoustic signal:
– ten short beeps: Siren
– longer tone: Camera (default setting)
11

Using the blind spot assistant

The sensors are activated automatically:
• when the ignition is turned on
• when the parking brake is released
Here the parking brake must be connected on plug socket 12 of the plug.must
be connected to
They stay active as long as the speed stays under 15 km/h. The blue LED in the LED
display lights up.
As soon as there is an obstacle within the detection range, the LEDs in the
LED display light up and a repeated, even signal tone is emitted.
As you approach, the different coloured LEDs show up in the LED display which zone
the obstacle is in, thereby indicating approximately the how far away it is.
Be very careful the first time you use the system, until you are familiar with the various
sequences with the LEDs in the LED display.
EN
Using the blind spot assistant
11