Using The Blind Spot Assistant - Dometic MWE 4104 Instrucciones De Montaje Y De Uso

Using the blind spot assistant

Setting the sensitivity of the sensors
➤ Press the "SENS" button briefly to switch to the sensitivity.
The sensitivity switches in the order "Low – Medium – High – Low ...".
✓ The LED display acknowledges the selected sensitivity with an acoustic signal:
– a short beep: low
– two short beeps: medium
– three short beeps: high (default setting)
Mode setting "camera activation" and "audio activation"
• Camera activation (default setting):
A long beep confirms activation of the camera mode. Trigger output is the red/
grey wire. The system indicates an obstacle by a 2 s beep once only and acti-
vates the connected video system.
• Audio activation (option):
10 short beeps confirm activation of the audio mode.
The system indicates an obstacle by
– one beep every 2 s in a range of 100 cm to 60 cm
– one beep per second in a range of 60 cm to 0 cm
11 Using the blind spot assistant
The sensors are activated automatically:
• when the ignition is turned on
• when the parking brake is released
(if the parking brake is connected to plug socket 12 of the plug.)
• when the turn indicator is activated
They stay active as long as the speed stays under 15 km/h and the turn indicator is
activated. The blue LED in the LED display lights up.
As soon as there is an obstacle within the detection range, the LEDs in the
LED display light up and a signal tone is emitted.
As you approach, the different coloured LEDs show up in the LED display which zone
the obstacle is in, thereby indicating approximately the how far away it is.
Be very careful the first time you use the system, until you are familiar with the various
sequences with the LEDs in the LED display.
10
MWE4104
EN