Operation - Moretti Forni PIZZY MONO 60.60 Manual Instrucciones

WARNING! It is essential that the appliance be properly
earthed.
A special earth terminal has been provided for this purpose under the
connection terminal board. It is marked with the earth symbol and
the earth wire must be connected to it.
These appliances must also be included in the unipotential system.
The terminal to be used for this purpose is located at the back of the
appliance.
It is marked with the symbol
When connection has been completed, check that the supply voltage,
with the appliance running, does not differ from the rated value by
more than ±10%.
WARNING! The flexible wire for connection to the power supply
must have characteristics at least equal to the model with rubber
insulation FG7R and must have a rated section suited to the
maximum absorption (see technical data).
2.5.2.2 ELECTRICAL CONNECTION OF THE LEAVENING
COMPARTMENT
WARNING! The compartment must be fitted with a main two-
pole switch with fuses or an automatic switch suitable for the
values shown on the plate.
NOTE: The device selected should be in the immediate vicinity of
the appliance and within easy access.
The leavening compartment is delivered with the a voltage of
230Vac. 1N 50/60 Hz, as indicated on the rating plate at the rear (fig.
1).
To carry out electrical connection, remove the protective cover
located on the left hand rear side of the compartment (fig.16).
The connection cable must be supplied by the installer.
Insert a cable with a minimum cross-section of 3x2.5 mm
cable raceway provided and then connect it to the terminal board as
illustrated in figure 15.
When connection has been completed, check that the supply voltage,
with the appliance running, does not differ from the rated value by
more than ±10%.
WARNING! The flexible wire for connection to the power supply
must have characteristics at least equal to the model with rubber
insulation FG7R and must have a rated section suited to the
maximum absorption (see technical data).
WARNING! It is essential that the appliance be properly
earthed.
A special earth terminal has been provided for this purpose under the
connection terminal board. It is marked with the earth symbol and
the earth wire must be connected to it.
These appliances must also be included in the unipotential system.
The terminal to be used for this purpose is located at the back of the
appliance.
It is marked with the symbol
WARNING!: The manufacturer declines any responsibility in
the event of failure to comply with the above safety precautions.
2.5.3 DRAINING OFF CONDENSATION
Connect a rubber tube to the connector provided.
3

OPERATION

3.1 PRELIMINARY CONTROL OPERATIONS
WARNING!
Before commencing start-up and programming of the oven,
always check that:
- all electrical and earthing connections have been properly
made.
- all vapour exhaust connection operations have been properly
made.
All control operations must be carried out by specialised
technicians holding a proper license.
3.2 STARTING UP THE BAKING CHAMBER
The control panel is located on the front right hand side of the baking
chamber, as illustrated in figures 21 and 22
3.2.1 PIZZY MONO VERSION (figure 21)
1. Thermostat for the FLOOR of the chamber.
2. Thermostat for the CEILING of the chamber
.
2
into the
.
3. Pyrometer indicating the temperature of the chamber
4. On/off indicator light for the heating elements in the FLOOR of
the chamber
5. On/off indicator light for the heating elements in the CEILING
of the chamber
6. Chamber internal lighting on/off switch, with indicator light
incorporated
7. Chamber main on/off switch, with indicator light incorporated
3.2.2 PIZZY DUO VERSION (figure 22)
1. Thermostat for the FLOOR of the bottom chamber.
2. Thermostat for the CEILING of the bottom chamber
3. Pyrometer indicating the temperature of the bottom chamber
4. On/off indicator light for the heating elements in the FLOOR of
the bottom chamber
5. On/off indicator light for the heating elements in the CEILING
of the bottom chamber
6. Bottom chamber internal lighting on/off switch, with indicator
light incorporated
7. Bottom chamber main on/off switch, with indicator light
incorporated
8. Thermostat for the FLOOR of the top chamber.
9. Thermostat for the CEILING of the top chamber
10. Pyrometer indicating the temperature of the top chamber
11. On/off indicator light for the heating elements in the FLOOR of
the top chamber
12. On/off indicator light for the heating elements in the CEILING
of the top chamber
13. Top chamber internal lighting on/off switch, with indicator
light incorporated
14. Top chamber main on/off switch, with indicator light
incorporated.
a) Turn the main chamber on/off switch on the control panel
(fig.21-22 item 7) to "on".
b) Set the baking temperature required, using the floor and ceiling
thermostats (1 and 2). The indicator lights 4 and 5 (fig. 21-22)
will light up to indicate that the heating elements in the floor
and ceiling of the chamber have been turned on.
Separate adjustment of the ceiling and floor temperatures
makes use of the oven much more elastic, allowing for more
customised baking.
NOTE: thermostat dials 1 and 2 are marked with a scale of
values from 1 to 10, which correspond approximately to the
following temperatures:
The indicator pyrometer shows the actual temperature inside the
chamber. As the bulbs of the regulator thermostats are located very
close to the heating elements, they are more susceptible to heat. For
this reason it is advisable to set these thermostats to a value slightly
higher than the temperature required, so that the heat throughout the
chamber will reach the required level (as shown by the indicator
pyrometer).
It is therefore suggested that you "customise" the thermostat settings,
referring to one or more of the values from 1 to 10 that is considered
best for your baking requirements.
c) when indicator lights 4 and 5 turn off, the oven will have
reached the temperature required.
The PIZZY DUO oven is fitted with two independent chambers. For
both of these, the instructions given above for the PIZZY MONO
version also apply.
UK/3
N. T.
1 50°C
2 90°C
3 135°C
4 180°C
5 225°C
6 270°C
7 315°C
8 360°C
9 405°C
10 450°C