Kit Purpose - Volvo Penta 3863124 Instrucciones De Montaje

KIT PURPOSE

This Trim Limit Kit is designed to limit trim to -2° to
+5° on DP-S drives and -6° to +12° on SX drives to
minimize undesirable handling characteristics and
possibly damaging the drive unit and propellers.
KIT CONTENTS
Part No. Description
3863007 Trim Sender (3 wire)
3855773 Electronic Unit
7742542 Installation Instructions
OVERVIEW
This kit involves two operations. The first operation
is the removal of the existing trim/tilt sending unit
and the installation of the new trim/tilt sending unit
Part No. 3863007. The second operation requires
the installation and calibration of the electronic unit
Part No. 3855773.
DANGER:
Ensure the boats electrical power is off and
disconnected from the wiring harness while
working on the electrical system.
TRIM SENDER REMOVAL
1. Disconnect rubber connector at wiring
harness on engine. Record the position of the
sending unit wires before removing. Use
Socket Removal Tool, Volvo Penta P/N
3854350 to push terminals out of rubber plug.
Note! The use of alcohol or equivalent will
make socket installation into the rubber plug
easier.
2. Remove the retaining clip from the grommet.
Qty.
1
1
1
3. Push the grommet out with a screwdriver.
Pull the wires through the hole, cut tie straps
securing wires to the trim/tilt lines, and
remove the trim sender.
4. Turn the gimbal to port and remove the two
screws holding the trim sender. Carefully
remove the sender and leads from the
transom shield.
TRIM SENDER INSTALLATION
42585
5. Apply Volvo Penta Grease P/N 828250 to the
new trim/tilt sender lead grommet. Feed the
wires through the opening in the rear of the
gimbal housing, and out through the transom
shield.
34495
ENG
34497
19475
34509
5