Equipment Maintenance; Daily Maintain; Troubleshooting - Selecta UV 3100 Manual De Instrucciones

INSTRUCTION MANUAL CODE 80260 REV A
J
.P. SELECTA s.a.u.
Feb/2017

6. Equipment Maintenance

To keep the instrument work in good condition, constant maintain is needed.

6.1 Daily Maintain

6.1.1 Check the Compartment
After measurement, the cuvettes with sample solutions should be taken out of the
compartment in time. Or the volatilization of the solution would make the mirror go
moldy. Users must pay more attention to the corrosive sample and liquid easy to
volatilize. Any solution remains in the compartment should be wiped off immediately.
6.1.2 Surface Clean
The cover of the instrument is with paint. Please use wet towel to wipe off the drips
on the surface immediately. Organic solution is forbidden to be used to clean the
cover. Please wipe off the dirt on the cover timely.
6.1.3 Clean the Cuvettes
After every test or after a solution change, the cuvettes should be cleaned carefully,
or the remains on the surface would cause measuring error.

6.2 Troubleshooting

6.2.1 Dark Current Error when Self-test
Possible Cause
Open the compartment lid during the course of self-test.
6.2.2 No Response After Power On
Possible Cause
Bad contact in power supply
Fuse melt
6.2.3 Printer Not Work, Printer Error
Possible Cause
No power supply
supply
Bad contact in power supply
Bad contact of the data cable
Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España
e-mail: [email protected] - website: http://www.jpselecta.es
(It can be modified without notice)
Solution
Close the compartment lid and switch on the power
again.
Solution
Improve the contact
Replace a new fuse
Solution
Switch on the power
Improve the contact
Improve the contact
Tel 34 93 770 08 77 Fax 34 93 770 23 62
Page: 52